Image Not Capturing

[george1421]

@magingmaster21
Please setup a debug capture (schedule a capture again, but tick the debug option) and then PXE boot the target computer. This will drop you to a linux command prompt on the target computer after a few Enter key presses. From the FOS comand prompt key in the following cat /proc/cmdline. Finally please post the output here. That kernel command line will tell us where the captured images are going.

[imagingmaster21]

@tom-elliott
https://dl2.pushbulletusercontent.com/KnT8DBusuB8NIqlannZ8MF0x9KxWVcZr/20180305_081343.jpg

[imagingmaster21]

@george1421
@Sebastian-Roth
@Tom-Elliott
Here is the output.
https://dl2.pushbulletusercontent.com/RfFZzXF7YP944cS61J2zmWdODXdZMPmn/20180305_084220.jpg

[imagingmaster21]

@sebastian-roth
I see the 94/97% on the Web UI, it does just jump right to it it goes through the process like it is working. The blue part clone does show up on the client and does act like it went through on the client but still shows as stuck on the Web UI.

[Sebastian Roth]

@imagingmaster21 said in Image Not Capturing:

The blue part clone does show up on the client and does act like it went through on the client …

What do you mean by “does act like”. Does it actually read data from the drive. I mean do you see the byte count go up at reasonable speed or does that jump as well? Sorry if this sounds stupid but I just haven’t got an idea yet. Maybe you can take a video of the client screen while this is going on. Possibly there is something that jumps at us.