Where can i get the new 1.53 install with the fixed Binaries from

[buercky]

@tom-elliott I just downloaded this afternoon. using git clone https://github.com/fogproject/fogproject.git

[george1421]

@buercky right, the binaries are updated when the fog installer runs. The git repo is just the files that need installing.

[buercky]

@tom-elliott I get through the PXE Boot and to the fog registration screen as soon as i click on quick or the full registration i get either a flashing cursor on a Dell Latitude 7480 or this screen on a Dell 7050 desktop it stops here

The funny thing is after the brand new install registration was working but after moving the DB and images over it stopped working

[Wayne Workman]

@buercky said in Where can i get the new 1.53 install with the fixed Binaries from:

after moving the DB and images over it stopped working

Did you turn off the old fog server and this problem happened? if so, probably your DHCP server needs updated - those steps are in that Migrate FOG article.

[buercky]

@wayne-workman I did turn off the old and updated the DHCP settings to point to the new IP address of the new server. They all seem to stop at init.xz… ok

[Wayne Workman]

@buercky Can you check the apache error log on the fog server? Maybe it has clues. Also check free space on the server with df -h

[buercky]

@wayne-workman I think space looks good Not very good at Linux but learning

And there are a ton of these errors in the apache log0_1527899149860_apacheerr.txt

[Wayne Workman]

@buercky Correct, space looks good. That error in the apache logs is not serious, it is concerning the bandwidth chart on the dashboard.

Just noticing here, @developers @moderators @testers is it normal for the message to be bzImage412 ? I’m refering to the screen-shot the guy posted a few posts below.

[fry_p]

@wayne-workman said in Where can i get the new 1.53 install with the fixed Binaries from:

Just noticing here, @developers @moderators @testers is it normal for the message to be bzImage412 ? I’m refering to the screen-shot the guy posted a few posts below.

I do not get the “412” at the end of bzImage to answer your question.

[buercky]

I’m so close to getting this working The only issue now is that i get now is a “no viable macs to issue” I re-ran the installer 15 min ago and that did not help per this thread https://forums.fogproject.org/topic/12006/fog-perform-full-host-registration-no-viable-mac-to-use/5
I renamed the .fogsettings file and re-ran the install still getting No Viable Macs to issue

So close yet so far