RC19 : Capture message "Attempting to check in"
- FOG Version: 1.3.0 RC-19
- OS: Debian 8.5
- Service Version: 0.11.5
- OS: Win10
Monday with RC-18, no problem to capture image.
This morning after RC-19 upgrade, message “attempting to check in” when trying to capture image…
@Matthieu-Jacquart yes did so just some seconds ago ;) working again ;)
@x23piracy You’ve made a git pull ? It works for me with svn 6002
same issue here with latest RC19, what can i do?
Ok it’s fine with last SVN ;)
And no, this isn’t work… Maybe my image is broken, I’ll test on another one tomorrow…
This issue is now more appropriately addressed in the latest and greatest. No, you don’t need to pull to get them, just re-run the installer and you will be fine.
@Wayne-Workman I knew where about it was introduced. I just had bad order of operations.
I was checking error status before I introduced it to the case statement.
I think it’s this:
I’ve updated the base code for the inits.
@dolf, I think we had the right approach, I just limited the calls for checks uninentionally.
If you look at the link I posted, you’ll see what I’ve added. Basically we had the "If target_size < device_size, and all the good suggestions you made.
We even had the elements that checked for success/fail etc…
However, I’ve added code in an attempt to more suitably test this. I will double check for more things just to ensure things are a bit better hashed out.
Please re-run the installer and the inits will have the modified code.
@Matthieu-Jacquart I’ve found the issue. I added more liberalized error checking to the way ntfsresize handles things so as to hopefully prevent breaking upload disks. While they do appear to be working, the “order of operations” was not properly taken into account due to me being a total imbecile.
@Tom-Elliott Each time I’ve got error message at upload (New size won’t be bigger than the device size) I’ve got this next reboot
Even if I resize disk on windows this is always same problem…
@Matthieu-Jacquart Reverting will do you no good.
Essentially it’s not seeing how much size will be available. I’ll take a look to see if there’s anything I can do to fix this. It shouldn’t have a problem though.
Here is the problem each time I try to upload image…
I tried but this time I’ve got an error message about size disk (can’t be bigger than…)
fdisk -l give me 30GB for main partition on a 128GB SSD disk…
What is the command to revert to RC-18 ?
You’re probably going to need to reupload as it doesn’t appear to have all of the data yet. Like the system is currently re-uploading, or in the process of uploading.
I don’t have this message anymore but I launch capture task 1 hour ago on the computer and there’s just this into /dev folder…
I’m going to see directly on the computer in few minutes…
Already fixed and pushed out. Please update.