FOG Client 0.11.1 - Printer Manager error

[Raymond Bell]

@Tom-Elliott FYI i just went back to SVN Revision: 5742 and now change

[Tom Elliott]

@Raymond-Bell that’s because all prints got associated accidental from a separate revision.

[Raymond Bell]

@Tom-Elliott said in FOG Client 0.11.1 - Printer Manager error:

@Raymond-Bell that’s because all prints got associated accidental from a separate revision.

So i going to have to go back and redo all printer associations ???For all 800 host

[Tom Elliott]

@Raymond-Bell Yes, but not totally.

Update your server again please.

Then hit me on chat, and i can try helping remotely please.

[Raymond Bell]

@Tom-Elliott said in FOG Client 0.11.1 - Printer Manager error:

@Raymond-Bell Yes, but not totally.

Update your server again please.

Then hit me on chat, and i can try helping remotely please.

OK will do

[Raymond Bell]

@Tom-Elliott Join.me sent

[Raymond Bell]

For others that may have this issue restore DB from back before today and update trunk…
@Tom-Elliott Remoted in and restored database from earlier revision… To fix the adding all printers issue.

[Tom Elliott]

It was an unfortunately thing that caused the “massive” printer issue.

@Wayne-Workman When you can, please check your layout too. Make sure you update again and let us know please.

Your issue is likely totally separate, and may require using the debugger.

[Wayne Workman]

I don’t have any printers deployed through fog yet.

[Tom Elliott]

Doesn’t matter. I need to see what’s happening (and why). Even if you don’t have any printers.

[Wayne Workman]

Ok. I’ll update tomorrow.

[Tom Elliott]

Last night Joe and I found a potential issue with the client in regards to the fog client having “bad” data and we patched it. With any luck, bad cycle data should no longer happen and this should be automatically fixed if it was a problem due to the bad cycle data.