HP EliteDesk 800 G1 TWR fails on undionly.kpxe and undionly.kkpxe

[Fogster]

Tried the new bzImage but still no luck with booting this on this new PC. Anybody have any other ideas?

[Tom Elliott]

Does it kernel panic? How long are you waiting to know its not working.

[Fogster]

It boots in seconds to the PXE image then runs a few steps and then stops and moves on to the next in boot sequence.

[Fogster]

No kernel panic on this one. I tried to run the register and inventory function from another laptop which is an older HP Compaq 6710b and it did exhibit a kernel panic error. The system I am trying to get working are HP EliteDesk 800 G1 TWR with Bios version 2.30 (dated 4/22/2014).

[Fogster]

Has anyone in this forum successfully booted unionly.kpxe on Fog 1.20 on an HP Elitedesk 800 G1? Please share specifics including fog
version and system bios version.

[madeyem]

Just so you know, the HP EliteDesk 800 G1 (TWR and SFF) will work with FOG 0.32, which I’m using.

[Fernando Gietz]

I have the same problem. The kernel don’t install the network card and if you do a ifconfig in debug mode, only appears the loopback interface

[Wolfbane8653]

[url]http://fogproject.org/wiki/index.php/HP_EliteDesk_800_G1[/url]

Just to throw this out. Which kernels have you tried?

[Fernando Gietz]

I just to update the FOG version, and with revision 2819 works fine. Now I have other problems with the dnsmaqs and tftpserver, but works fine

[Wolfbane8653]

So i can add this to the working hardware page?

[Fernando Gietz]

I think that you can do it