inaccessible boot device
-
Hi all,
So I’ve deployed a windows 10 image to a hp z2 g9 pc, it’s written the image to the disk, as I saw it doing the part clone process but when it succefully completed, it then rebooted and loaded up windows, once it rebooted to load windows, I have a blue screen of death with a stop code
inaccessible boot device
I have deployed the same image to a VM and a hp laptop with success, so maybe it’s something to do with this pc
Thanks,
Rob -
@robertkwild Which version of FOG do you use and is the image type resizable or non-resizable?
-
@robertkwild said in inaccessible boot device:
something to do with this pc
…perhaps and most likely yes
I had the same issue in the past…my Default Image was created in VM environment…but when i deployed it, i get the same BSOD.
Make sure you check all of these :
- Storage controller in BIOS is set to the same of the PC/VM from where u had captured the “default” image. (probably AHCI) and the boot option (MBR or UEFI) is the same.
- (in my case…but i can’t exactly explain why) Before you capture the disk, the partition aliment is in this order : 1 Efi System Partition ; 2 Recovery Partition ; 3 “C:” partition (that is Boot partiton).
Good luck.
-
Sorry taken ages to reply, just busy this week at work
It’s fog v1.5.10 and single disk resizable
As said I can deploy image fine on other machines, just not this dam hp z2 g9
-
@AlexPDX @Sebastian-Roth it was something simple in the end
BIOS > advanced > system options
i turned off/unticked - configure storage controller for VMD
basically its there version of RAID, untick it and its AHCI
-
[[undefined-on, S Sebastian Roth, ]]
