Deploying Image to SSD
-
I believe you need to first make sure, in 1.2.0, that there’s a partition table laid out on the SSD.
-
fogpartinfo --list-parts /dev/sda shows the correct partitions and the device does have a label msdos. It copies /dev/sda1 correctly and starts copying /dev/sda2 and fails after 3 seconds and I don’t see an error or anything, just restarts.
-
Make sure your storage node isn’t full?
Just a stab in the dark…
-
is your image resizable or single disk (not resizable)?
-
Resizable
-
Tom suggested I update and recapture the image, so I did and I’m still having issues. The same image will install on the laptop with standard HDD and now I’m getting a weird error. See attached screenshot
-
Oh I forgot to mention, storage node is good.
-
@James-Harting
Check for firmware updates for the SSD?
I had one made by Crucial and that thing was so jacked… a firmware updated fixed it though.
-
Ahhhhhhhh, ok so I feel kind of stupid, but I completely forgot someone just upgraded the ram on it before giving to me to test. After I put the original memory back in, all was well!!!
-
That’s incredibly strange… but ok.
-
Is this solved then?
-
I will let you know shortly.
-
@Wayne-Workman said:
That’s incredibly strange… but ok.
Some SSD can be used as RAM. That function is available via a driver. I tested it under linux.
I suppose that if the image is uploaded with a certain quantity of memory, you have to restore it with the same quantity…Just a thought.
-
@ch3i said:
@Wayne-Workman said:
That’s incredibly strange… but ok.
Some SSD can be used as RAM. That function is available via a driver. I tested it under linux.
I suppose that if the image is uploaded with a certain quantity of memory, you have to restore it with the same quantity…Just a thought.
That might explain quite a lot of problems that people have been having with SSDs.
-
Yup, it’s solved.