No Image file found that would match the partition

[msi]

@sebastian-roth

[Sebastian Roth]

@msi Looks like you keyed in the command too early. Hit ENTER a couple of times after the error till you get to a real command shell…

[msi]

@sebastian-roth

With raid on from the bios ATA

[george1421]

@msi what does the output of lsblk ?

[msi]

@george1421 gives blank response.

[george1421]

@msi Well I think you found the issue. You do have a hard drive in that computer

[george1421]

@msi Just for clarity this is a dell computer booted in uefi mode, with a disk mode of raid-on?

[msi]

@george1421 Yes.

[george1421]

@msi There is a know issue with the linux kernel (Not FOG) booting in uefi mode with disk mode in raid-on. If you switch to ahci mode then linux (FOS) will see the disk. Leave your current debug task running, just manually reboot the target computer, update the firmware with ahci mode, then boot back into fog imaging. Then run the lsblk command again. This time you should see your disk. You can either leave in ahci mode or switch back after imaging.

[msi]

@george1421 You’re right. You want me to deploy now?

[george1421]

@msi I would surely try. The disks can now be viewed.

[msi]

@george1421 Same problem.