Also I noticed if I am in the host section and update a record a message pops up extremely fast on the screen before it redirects.
FOG ERROR: Location: Record not found, no data array or ID passed.
That is not the verbatim message, I had to click it 10 times to read it all.
This is if I delete them through the website after they have been registered. It seems to have something to do with maybe not setting the image or the operating system? I am not sure but some work, some do not work. I also ran into this after one was registered and I change the station name, then tried to delete it.
It may be morning time, I am not currently at the office. I will get you a screenshot in the A.M.
Strange problems are popping up, and not once, this is at least 3 host I cannot delete. Errors keep popping up on the web page, is there a way to delete them in the database and which tables do I remove them from?
There error is something like ID is invalid
Well the are centrally managed, so I doubt I will be allowed to change settings.
I think it is our switches, they are Cisco switches managed by higher powers. I think they are 3750g’s if I remember right.
Okay I tried multicast again before I left work. I setup 3 Dell Optiplex 9020 computers and assigned them to a group, after I assigned the image I started them on multicast. When they started the multicast they did actually start this time, they got to partition /dev/sda1 and just sat there. They never did start /dev/sda2 and I gave it 5 minutes, this is a Windows 7 image so it should only take a second. I turned them of and assigned the job to a single machine and it went just fine.
The multicast thing is not a deal breaker by any means. It would be nice, but not a huge deal.
Well I am okay with that. I am glad they did not purchase 2tb drives at this point then.
So let’s say I have these 55 Dell’s deployed and later on down the road a drive fails. Can I pull out one of these 500gb drives and replace it with a 1tb or 2tb drive? Will it fail on the reload? I did single drive, multi-part non resize. I am not concerned about the smaller partition because I can resize it with a utility.