Topics created by jhalbert

@tech49 Please make a new thread for the new issue so we can help you there. (since it’s unrelated to the thread)

@george1421
nothing for grep BUT I started to read messages…
FIGURE IT OUT
My raid controller is the problem. I don’t have two m.2 and I have two sata. The controller managed all 3 drives. Because the raid controller said it only has one raid AND that is it in fogs logs. windows knows how to deal with it because the drivers were load in during install.

I turn off raid mode and rebooted. Found all 3 drives. Now because of my setup, I am going to unplug those sata drives from the board. upload the image. THEN Grab a new one and restore with raid off. Then plug the drives back in. Should just work.

@george1421 I left it all alone. I did ran my test and everything deployed just fine. Tried on 20 pcs and everything work just like it was during testing. How do I close? Can you close or how can I?

@jhalbert You need to setup the location plugin: https://wiki.fogproject.org/wiki/index.php?title=Location_Plugin

Assign your nodes locations, and assign those hosts at that remote site to the same location. After this, those hosts will only image using that location’s server.

@wayne-workman yes but I would set a windows task to manage the updates. I found fog daily work fails once the client fails. Then I don’t have daily info that I was aiming to collect.

@sebastian-roth THANK YOU!!! I did not use the right username and password for MySQL. Now the node is downloading and web says not here like normal.

@wayne-workman Thank and it is working!

@jhalbert said in Snapins does not deploy:

an I reset encryption on 600 pcs? Can I use a script or is their a place where I can reset them all?

Use the web interface - put all of them into a group called “all” and use the group to reset the encryption on them all.