Alternative Multicasting Methods?

[Wayne Workman]

@zacksiga So according to that output, your interface name is ens32

You should set this as the interface name in your storage node settings and then try to multicast again.

[zacksiga]

@Developers, @Tom Elliott, @Wayne-Workman . Funny thing is that when you created a session it only last for 10 sec or so , and disappear, same thing with multicast when you do it with a group, it shows up in active multicast for 10 sec and disappear like it was never multicast session to being with .

[Wayne Workman]

@zacksiga Well, after you set the interface name inside of the storage node settings, you hae to restart the FOGMulticastManager.

Apologies for not including this earlier.

[zacksiga]

@Wayne-Workman Thank you very much that was my the big problem, soon as I changed the interface everything seem to work. Couple of area of concern for the new svn, compare to the last svn

[Wayne Workman]

@zacksiga said:

Couple of area of concern for the new svn, compare to the last svn

?? I don’t see any issues, could you be more specific? thanks for the photos though.

Also - All the props and thanks should go to @Tom-Elliott he knew exactly what the issue was, I was just a milder sounding-board.

[Tom Elliott]

@zacksiga I don’t follow what the problem is.

The “black and blue screen” you see there is because the system can’t use the “vesafb” method.

[zacksiga]

@Wayne-Workman I have another machine that has Ubuntu 12.04 that has multicast issues, for the interface it has eth0 and ip link shows

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc mq master bond0 state UP qlen 1000
link/ether 00:1e:c9:d7:2f:d2 brd ff:ff:ff:ff:ff:ff
3: eth1: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc mq master bond0 state UP qlen 1000
link/ether 00:1e:c9:d7:2f:d2 brd ff:ff:ff:ff:ff:ff
4: bond0: <BROADCAST,MULTICAST,MASTER,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP
link/ether 00:1e:c9:d7:2f:d2 brd ff:ff:ff:ff:ff:ff

what are your thoughts, I tried using load balancing feature, but I don’t think its working

[zacksiga]

@Tom-Elliott
The menu used to show up with the fog logo and everything before we update the svn.

[Wayne Workman]

@zacksiga try the bond0 interface.

[Tom Elliott]

@zacksiga This is now fixed. Apparently when I updated one time, the console.h file didn’t transfer over properly. It isn’t even seen on SVN history for whatever reason. I have now fixed this. The background image should display properly as it used to.

[Wayne Workman]

@Tom-Elliott Is the console.h file an actual image? Where is it located?