Pxe-e53 no boot file name
-
when you set up your fog server did you set up the static ip address as the same ip address you had before? You will need to update your DHCP scheme to include options 66 adn 67 to point to your server and your boot image respectively.
Are your switches standard hub style switches or are they managed switches?
What Ubuntu version did you install and what version of Fog did you install?
-
ubuntu is 12.04
fog is 0.32
router was changed from a dlink so the static ip is now 192.168.1.200 (was previously 0.200 but changed when reinstalling ubuntu and fog after dlink died)
first switch is an unmanaged dllink dgs-1016D
second switch is a 3com superstack 3 4200 (cant find a definitive answer on if its managed or not)
also I was able to pull and deploy an image fine before the router switch and reinstall of ubuntu and fog (forgot that in original post)Again many thanks for the help
-
It looks like the 3com switch is a managed switch, but I don’t think that’s quite your issue.
As you state the static IP Changed from 192.168.0.200 to now, 192.168.1.200, is all of your FOG stuff pointing there, and is option 66 pointing to the new server.
Option 66 on the DHCP Server should be, now, set to the new IP address of the FOG Server. This should give you back pxe menu.
In the FOG Management side of the house, you’ll likely need to make the changes to Storage Management->Storage Node, FOG Configuration (Other)->FOG Settings-> FOG_TFTP_HOST, FOG_PXE_IMAGE_DNSADDRESS (This will probably be the new Dlink’s gateway address.), and FOG_WEB_HOST.
Did you install FOG with or without a DHCP Server?
-
FOG_TFTP_HOST = 192.168.1.200
FOG_PXE_IMAGE_DNSADDRESS = 127.0.0.1
FOG_WEB_HOST = 192.168.1.200
fog was installed without dhcp
(didn’t change any of these its what they have been since the reinstall after router died)
error still persists
again thanks for the help
-
What device is serving DHCP for this network segment?
-
The new Linksys EA6400 is doing the dhcp
-
Do you have a management console for the Linksys EA6400?
There may be a setting for “Boot file name” that we need to edit to allow pxelinux.0 to boot.
-
I see no setting for boot file name, but I’m not used to linksys’ new interface. I’ll give it a bit longer but I think I’m going to go with my backup plan
again thanks for the help
-
You can try to install the DNSMasq service to serve a “proxydhcp” server for pxebooting, I ultimately had to in my environment, it couldn’t hurt giving it a shot. It will try to help your clients to resolve to the pxe server.
-
After searching through the interface for the EA6400, it doesn’t appear to support PXE boot options. Just use DNSMasq as Jaymes advised. It will let your Linksys router serve DHCP, and just respond with PXE Boot information to those clients that request it, such as next server name and boot file name, no IP info.
