Image creation and network connection
-
Hello,
Although I have used other systems for imaging, I am new to the FOG Project.
I am working on an image for a new set of systems we have. They are Framework Desktops. I assembled the first one and got Win11 installed. I cleaned up the disk and then got the system registered and the new image listed and associated with the system it is coming from. I then reboot the system and go back into PXE and I can get past the PXE initiating. It sees and grabs the servers IP address then it loses the connection and cannot proceed with the image creation. I had it run the compatibility, and it is only showing a loopback addy and no IP address in the network test. If I boot into windows, it is fine and connects with the network and the internet. In the compatibility section if I run #4 (test compatibility) it passes everything. We have over 40 images and they work in this system all the time. I am at a loss and would appreciate any help we can get. I had read in another thread here that there may be an issue with the drivers for the network card not being in the system. -
@BLT Hi I am working on an updated kernel that should support newer hardware like the Framework Desktop.