Kernel Versions blank

[rogalskij]

Current version - 1.5.10.1598

Several versions ago, I found t hat under the “Kernel Update” tab, it no longer shows me which Kernel versions I have installed. If I clicked on “Default Member FOG Version: ()” it would list what versions of the kernel were installed. It stopped working some time ago, and I didn’t mess with it. Is there an easy fix for this? I have tried updating and a few small changes but no luck. Not a huge deal, but would like it back if I can. Thanks everyone!

[Tom Elliott]

@rogalskij I’m unable to replicate the problem:

I’m assuming this is what you mean?

[rogalskij]

@Tom-Elliott Correct, in yours you see the bzImage and arm_image, but in mine it is totally blank for some reason. Been like this for quite a while and I have no clue what I did to cause it. Unless it is potentially just a browser issue or something with my PC only?

[rogalskij]

UPDATE

After some investigation, I found that if I connect to FOG using the FQDN, the Kernel versions show. If I connect via IP address, which I had been previously, it doesn’t show. This was on a machine with our Endpoint protection enabled. On a machine without any endpoint protection, both IP and FQDN show the Kernel versions. Strange, must be some sort of overzealous web protection on the part of our endpoint software. Thanks for your help @Tom-Elliott !!!

[Tom Elliott]

@rogalskij so it seems your “ipaddress” is defined as your fqdn either on the IP address for the storage node directly.

I don’t know what your storage node settings look like but should be looked at likely from:

Storage Node-> DefaultMember

HOpefully that will help.

Normally if you can dereference the DNS name all would be fine so I’m just not sure where to help out.

But at least you know what is happening now?

Thank you for letting us know.