Bandwidth -Transmit
-
I cannot find where to change the default member for the Bandwidth Transmit monitor. Since updating to trunk, my bandwidth monitor on my home page, reads WLAN0, and it needs to read eth1. Can someone tell me where to change this? I cannot find anywhere in the gui, or config file to change this! To clarify, imaging works fine, everything works fine, just my Bandwidth transmit monitor shows blank while i’m imaging, driving my OCD out of control. Thanks in advance, -Jeff I also apologize in advance for not being able to find my answer to this via search.
-
Moving this to bug reports as I remember @Tom-Elliott having changed the interface configuration/discovery code not long ago.
-
@Sebastian-Roth the bandwidth page uses the interface defined in the storage node definition.
-
Ok, sorry then. Moving to FOG problems.
@pizzutoitalia Please check your Storage Management settings on the WEB GUI…
-
This was solved by changing interface defined in storage node, just as Tom said! thanks!