PXE image looping
-
@ManofValor I know its probably too late, but I would have done the /opt mount point instead of /opt/fog/images. That way all of the opt stuff would go into that 400GiB drive. What you won’t get is /opt/fog/snapins that will still go onto the root partition. Sorry I was late, stuck in a teleconf call for 2 hours.
-
@george1421 said:
I know its probably too late, but I would have done the /opt mount point instead of /opt/fog/images.
It’s not too late. I’d say go back and do it right.
-
@george1421 I haven’t gone any farther than the pic. Waiting to make sure I do this right.
-
@ManofValor Ok then just change the mount point to /opt and you should be good to go.
Linux (*nix) is a bit confusing for the windows folks. As windows gets older it gets more features like *nix. This whole mount point is cool once you understand it. Its a bit like what DFS is but on a local hard drive concept. You can traverse between hard drives or network shares for that matter, but just changing to a different directory. From the UI level there is no
drive or d: drive. The d: drive would just be mounted to a directory and you would change into that directory for data to go onto the d: drive. -
@george1421 Why using /opt/fog/images? As Wayne already said: “I would prefer though to mount the 2nd hdd to /images because /opt/fog/images is a deviation from the expected.” Both will work, but sticking with the default (/images) might be wise as well. @ManofValor Up to you.
-
@Sebastian-Roth The logic is that the snapins (which could also be huge) would not be captured if only /images were mounted over on the new disk. My preference would be to keep EVERYTHING fog related in /opt/fog. (But I’m one of those type ‘A’ people, so that that for what it is. )
-
@Sebastian-Roth Seeing that I am an infant (maybe a toddler by now) with this stuff I just went with a recommendation/suggestion.
-
Ok, so CentOS is installed. We’ve done so much I just wanna make sure I take the right steps again. I just go straight to installing fog trunk right?
-
Give it a go I’d say. Make sure your internet connection is fine so that kernel and init files are properly downloaded.
-
@Sebastian-Roth said:
Give it a go I’d say. Make sure your internet connection is fine so that kernel and init files are properly downloaded.
Easier said than done. You might want to shoot him a PM. Poor guy keeps having a lot of network issues. I did some troubleshooting and I think his router isn’t letting the fog server’s traffic get out. He says there is no proxy but I’m not so sure about that.
-
@Wayne-Workman I’ve checked and asked my boss, who built our system from the ground up, and we are not behind a proxy.