Kyocera TASkalfa 5040ci - won't staple or punch
-
I hope I’m in the right place for this.
I added this printer to FOG and provided the path to the .inf file and made sure the nodel matches that in the .inf file.
But when FOG installs this printer to a host, the staple and punch options are not availble.
Any wisdom? -
THis only occurs with a FOG install, not a manual install.
-
@lstassen is the driver the one you expect from the inf when it is installed via fog?
When manually installing are you running an install package?
Is there maybe a device settings tab where you need to tell the driver that the printer has the feature. You can use the fog printer settings file to save and deploy such settings. I haven’t used that feature in quite some time but I helped make it and this type of configuration was why it was added. -
@JJ-Fullmer Thank you for these suggestions. Yes, I am using an install package when doing it manually. I have looked all through device settings, and while I can find the punching feature, I can’t enable it.
I will look into FOG printer settings as well as FogApi powershell module. Haven’t delved into these yet.
Thanks again.