@george1421
Hi,
I reshaped and deployed the image
All is Ok now
thanks for your help

@george1421 said in Error for create image:

OK so the question is what is in the 4th physical partition on that hard drive. FOS is reporting the structure is incorrect. If you take a similar system and try to capture it do you get the same error?
My idea is that this hard drive has a problem in its partition layout. The operating system doesn’t appear to have an issue with it, but when its cloned partclone isn’t happy

I did not have time to do this test
I will do it Monday and I will inform you
Thank you and good we

@oliviert82
I did the tests with the Dell utility and the chkdsk / r command and the result is always the same

@quazz said in Error for create image:

4 partitions was the default for Windows 10 UEFI. I think they changed it to 3 for new installs down the road somewhere, though.
Anyway, you should run chkdsk /r on every partition. Boot of a Windows 10 install media, assign letters to each volume, run the check.

I’m checking the disk with the command chkdsk / r
I give you the result as soon as it is finished

@george1421
Apparently no problems detecting with the Dell Utility - I initiated a thorough review

@george1421
I ran the Dell Utility
I give you the result tomorrow because I have the PC at my desk
thank you for your help

@oliviert82
i use Dell utility

@george1421 said in Error for create image:

Ok no problem. I’m in the USA but I am usually on until I go to bed. I would scan this target computer to see if windows can find the flaw on partition #4

You want me to scan with what as a command
Chkdsk?

@george1421
I am sorry but I have to leave - I try to continue to exchange on the subject - I do not know in what country you live, so with the jet lag !!!

@george1421
Yes it is a pc in OEM
A few months ago I had already captured it and it had worked well - I had a mistake of this kind and I had run the command powercfg - h off and then it had worked

Is this really the same message? I remember it more accurately - in any case I execute this command and always the same thing

@george1421 said in Error for create image:

I’m asking about the computer that printed the error in the picture. Tell us a bit more about that.

Is the above information sufficient?
I have this message after booting on the PXE