I did use multiple partition single disk.
HP 6000’s simply dont image properly.

sh int in my cisco switch on the port that fog is plugged into shows 800mb/sec. The graph was only showing 10mbit.

Seems to happen anytime its over 100mb with unicast traffic.

OS is Ubuntu.

What information do you need? I will gladly provide it

Microleaks,
can you give me more information about this fix? [url]http://freeghost.svn.sourceforge.net/viewvc/freeghost?view=revision&revision=882[/url]

It seems imaging a windows 7 machine with more then 2 partitions on a single disks always does not work.

It will go into windows startup repair then give random windows error messages.

THe current drive has the following.
boot partition
os partition
recovery partition

The graph on the main screen of fog says 100mbit transmitted.

On the switch that server is pushing 800+ mbit.

Graph is very off.

Fog 0.32
eth0

Trying to upload an image and it got about 80% then the error below shows on screen and it never finishes.

HP 6000 single disk. chkdsk has been run.

What is process pigz and why is it hungup?

Frustrating!

[COLOR=black][FONT=Tahoma][2640.688033] INFO: task pigz:284 blocked for more than 120 seconds
[2640.688075] “echo 0 > proc/sys/kernel/hung_task_timeout_secs” disables this message.[/FONT][/COLOR]

Running 0.32 with more hp 6000 we are getting 50mib multicast.
sata operation mode is ahci.

There is something with the kernel and this hardware set that is making this really slow.
any solutions?

We were running fog 0.29. I upgraded to 0.32 and we are now getting in the range of 300-400mib. The problem is with these hp 6000 and their hard disk controller and or bios and or hard disk. The newer kernel included with 0.32 is working great. I will test again with the sata operation mode in “ide” I have seen others claim they get very high speeds with this change.

It should only show N/A or hide the column if its not a single partition. Just a suggestion.

On the active multicast tasks screen the status always says 0% for any multicast session.
The sessions finish and work but the status never changes. Had same problem in 0.29 and still exists in 0.32