@Sebastian-Roth I could try analyzing the traffic coming into the fog server during an attempted PXE boot to see what’s going on, I’ll report back in a while with the findings.

@Wayne-Workman The problem has been solved. Thanks.

@Wayne-Workman I contacted the vendor today, and unfortunately I can’t make changes to the partitioning system.

@george1421 This is a product that we resell, that is CentOS based. I’m not sure if I even have the choice to configure the disk layout. I’ll have to check tomorrow when I build another one.

Server

• FOG Version: 7887
• OS: Fedora 23

Client

• Service Version:
• OS: CentOS 6

Description

I’m trying to capture an image from a CentOS 6 box, and the image is uploaded as a 240 GB raw image.

This is part of the output from fdisk -l

Device Boot Start End Blocks Id System
/dev/sda1 * 1 13 102400 83 Linux
Partition 1 does not end on cylinder boundary.
/dev/sda2 13 29186 234327040 8e Linux LVM
Partition 2 does not end on cylinder boundary.

I’m not really clear on what settings I should use to capture this image. I read that I can’t use single image resizable for LVM. I’m surprised I didn’t get any error messages. Is there a way I can capture this without it being raw?

@george1421I’ll run tcpdump on that interface tomorrow when I get in and see what happens during the PXE boot.

@george1421 Under boot options, it lists UEFI and legacy. All of the boot devices are set under legacy mode, including the NIC.

I just logged into the PFSense box and was set up for undionly.kpxe, I tried switching to undionly.kkpxe but got the same error. I’m assuming that the boot files under /tftpboot are the options available to me? There are a lot of them there, not sure if I should just start cycling through them, trying them all until one works?

1. PFSense is handling DHCP. I’ve been using this setup for a while now and it works great.
2. Yes I can image from other models. 90% of what we do is on an Asrock Z97E board.
3. Legacy mode. We’ve had issues with images not restoring properly if the install was done in UEFI.

How do I change the boot file? It seems like I’ve had to do this in the past but can’t remember what needs to be edited, or where the config file is.

Server

• FOG Version: 1.2.0 7887
• OS: Fedora 23

Client

• Service Version: Intel NUC Kit NUC6i7KYK
• OS: CentOS 7

Description

I just configured a system on a Skull Canyon NUC, and wanted to create an image. I tried PXE booting to my FOG server and received “PXE-EC8: !PXE structure was not found in UNDI driver code segment”

It then exits and boots to the hard drive. This happens instantly, and I had to take a picture of the screen to even read the error message.

I looked up the error, but the description didn’t really help me understand where to look, or what the solution might be. Any help would be appreciated.

@Wayne-Workman The problem has been solved. Thanks.

I did not see that there was a dedicated tasks section. I’m still learning to find my way around the web GUI. The issue has been resolved, thank you!