@Wayne-Workman is this what I should get from the CLI commands?

root@HAW-FOG-01:~# ethtool eth0 | grep wake-on
root@HAW-FOG-01:~# ethtool eth0
Settings for eth0:
Supported ports: [ ]
Supported link modes: Not reported
Supported pause frame use: No
Supports auto-negotiation: No
Advertised link modes: Not reported
Advertised pause frame use: No
Advertised auto-negotiation: No
Speed: 10000Mb/s
Duplex: Unknown! (255)
Port: Other
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Link detected: yes
root@HAW-FOG-01:

also another thing I just came to my mind. this will not work if there are VLANs established?

@Wayne-Workman I did that as well and once I enter that command nothing happened. so I’m assuming it enabled it ??? but when I check the eth0 settings WOL is not on there.

@Wayne-Workman So I just installed ethtool and tried this command

ethtool interface | grep wake-on

Cannot get device settings: No such device
Cannot get wake-on-lan settings: No such device
Cannot get message level: No such device
Cannot get link status: No such device

and these are my results

I have tried it and it just brings me to a FOG window and it is just blank.

Hello, everyone, I am having issues with my fog server. I am not sure if wake on LAN it is set up on the server. I work for a school district supporting 5 schools and I would like to set up FOG to deploy images from my desk instead of going to each school and going computer by computer. I hope this is possible if not its not the end of the world it just saves time to work on other things. Thank you if anyone is able to help.