Posts made by JimmyJ0516

@george1421 it worked flawlessly I have all of them up and running now thanks again.

@george1421 You’re the man lol. Here I can see that 5.9.3 and I see both the loopback and the NIC.

@george1421 I did it again. I see it shows 5.6.18 as version but I only see the loopback address when running IP a s Screenshot

@george1421 sounds good I am doing so now. The last time I did this I used WinSCP and threw it onto the home folder and then moved it to the directory you specified. I tried going directly to the directory but I had a permission error. Once I get the file Copied over I changed its permissions to 755 as all the others have that permission. is that ok before I do it again?

@george1421 Of course Thanks for the help. If you need any help from me just let me know.

@george1421 so support is out for it correct

@george1421 I looked for 8169 and 8125. This is what I found

@george1421 I am sorry. Looking back I typed nm instead of nn here the correct screenshot output let me know if you still need me to go through the logs messages.

@george1421 I ran the command and cropped out every other network adapter but the 3:00.0 which is the one we are working with. Here you go

@george1421 Ok I did so. I am still in debug mode as well. here are the screenshots

@Sebastian-Roth ok sounds good I just did it. Thanks. I scheduled the task and I am currently in the debug state I am not sure what to do next. I am still getting the same error message I was getting before.

@george1421 ok, I have the file in the directory. but the owner of the file is the Administrator is that going to be a problem.

@george1421 it’s on a motherboard which is an MSI MPG Z490 Gaming Plus LGA1200. I think that’s what you’re asking for.

@george1421 It fine no worries. The district might be closing so I have time. Thank you again and please take your time there is no rush

@george1421 Perfect thank you so much. I really appreciate it.

@george1421 Yes I only see the loopback address I also attached a picture here

@george1421 5.6.18 was shown when running uname -r so that worked with no issues. After running the other command I got a result of 10ec:8125

@george1421 Thanks for replying back I have updated my kernels but I am still having the same issues.

Hello everyone,

I recently built 8 machines for our STEM room. I am now trying to use the perform full inventory option during PXE Boot so that I can add the computer to FOG and Capture its Image. I keep receiving this message No Network interfaces found, your kernel is most probably missing the correct driver! Please check your network setup and try again. I have added a screenshot as well. FOG Error message. Any help would be greatly appreciated thank you.

@george1421 Thanks again