Just realized the two partitions I was trying to use were on the same disk… just deleted the one I was trying to expand with and extended the size of the one currently in use.
LVM would have been another way of going about it had I been using two separate disks like I thought I was. Thanks for your attempt at helping!
#close
I’ve seen mention that the database is different in 0.33, and there is no possibility of returning to 0.32 after upgrading. My question is: are 0.32 images compatible after upgrading to 0.33? It was also suggested to install 0.33 in a VM, but is that still relevant?
I’m thinking that grabbing from SVN and running the install will be all the configuration I’ll need… is that correct?
Thanks!
I have run out of space, yeah. I have another drive that I wanted to supplement the first one - I can’t use it as a replacement because it’s smaller.
I’m thinking of upgrading to the 0.33b trunk, but I’m not sure if that would impact my situation or not.
Edit: The other thing I was going to look into was LVM… creating a logical drive that combines the two in use. That would solve my storage issue, but I’m not sure when I’m going to have the time to get that working.
At the bottom of [URL=‘http://www.fogproject.org/wiki/index.php/Moving_your_images_directory/Adding_Storage_to_the_Images_directory’]this[/URL] page it says the following:
[QUOTE]If you want to just add capacity to your images directory, you could instead mount your new device as a subfolder of the /images directory. In this case your wouldn’t need to move the original directory to /images1, and your fstab line would look like:
UUID=XXXXXXXXXXXXXXXXXXXXXX /images/newdisk ext3 defaults 0 0[/QUOTE]
I’ve done this, made sure it mounted, but it’s not being detected anywhere that I can tell, and any images set to dump into (or pull from) that directory get errors or cannot be found. What could I be doing wrong?
Thanks, that worked perfectly!
I plan to be making a donation very soon… or will get my boss to do so.
Hello!
First off, I would like to say that FOG is saving me so much trouble when it comes to image and inventory management. Although we have had some issues with reliably installing printers using the printer manager, we have had no other major problems.
However, when trying to remove a host, I get the message:
[CODE]Failed to remove host!
Query Failed: Table ‘fog.pendingMACS’ doesn’t exist[/CODE]
And when viewing the edit host general tab, I see the following under each MAC address:
[code]Error retrieving Pending MAC addresses[/code]
It appears that the fog.pendingMACS table was not installed/configured properly. I’m not certain if this is because we installed 0.30 and then immediately upgraded to 0.32 and it got messed up in the conversion process, but I have lightly googled/searched the forum and found nothing similar.
Any ideas how I can rectify this? I’m going to settle for changing the hostname of the machine to DELETE_ME so I don’t mess up my inventory, but this is definitely not a permanent solution.
Looking forward to 0.33!
Thanks