I recently upgaded to FOG Trunk 6541. Joining active directory was working before the upgrade took place. Now, it is not. All settings on the fog server look proper and the hosts are set to join the domain after the image task. The hosts restart to get renamed but do not join our AD Domain. Is there any troubleshooting steps that i can take to help resolve this problem?
Any help is greatly appreciated
@Sebastian-Roth Thanks. It just so happens that our school is running Windows Server 2008 R2. So… These steps are not going to work according to the document…???
I will go in and fiddle with it for a minute. Just to see.
@george1421 Yeah, i suppose so!! I was booting my HP Stream 11 off of the usb to ethernet adapter. At the same time i am network booting a HP 4530s from its internal Network Card.
It is working now thanks for everyones help!!!
However, now when i am booting another device that was working before the change, I get an error that says “NBP is too big to fit in free base memory” is there any way around this?
Thanks Again!!
@Tom-Elliott I have already replaced the ipxe.efi file in the /tftpboot directory… any other suggestions?
The screen that flashes quickly show the
Workstation’s IP, Server’s IP, NBD Filename is undionly.kpxe, NBP Filesize. Downloading NBP file… Succeed to download NBP file
I then proceeded to replace the undionly.kpxe file with the one from This Site… Still have no luck pxe booting into fog
Ok. I can PXE boot all of my wired NIC devices now.
So far, i have upgraded to FOG Trunk 6541, Kernal 4.4.3, and i have replaced the ipxe.efi binary.
When checking the DHCP Settings, we have Windows Server 2008 R2, Do we still have to point it to the “undionly.kkpxe or ipxe.pxe/kpxe/kkpxe” binary files as @Sebastian-Roth was saying?
Also, @drc0nc I disabled legacy boot on the streams. When i network boot it, it says Start PXE over IPv4… then it quickly flashes an ip address and some other info that i could not catch that quick. Then it boots into windows.
Thanks and sorry for the wait!
@drc0nc Alright. Thats above my paygrade!!! I will have to have my superior check on that when he gets back on Monday! Thanks for your help!!
Hello, I am using an official HP USB to Ethernet adapter.
AX88772C/772B/772A/772…
Also drc0nc said I have to use the ipxe.efi binary. Should i grab any of the other file from
PXE Binaries??
Thanks!!
Alright. I think I made reverse progress…
So, I logged into the fog server and created a host for the HP Stream 11 using the USB to Ethernet’s MAC Address. and when doing so i added the arguement “has_usb_nic=1” for that host.
Now i am trying to image another machine that has a ethernet card built in. and it to is getting hung up at “iPXE Initializing Devices.” Maybe there is an issue there now???
Thanks for your speedy reply! Where do i put this argument exactly?? is it in a config file for Ubuntu on is it entered somewhere else?
Hello, I have a functional FOG Server 1.2.0 running on Ubuntu 14.04 with a few images on it. Devices that have a built in network card are working with no issue. However, these HP Streams do not have a built in network card. I am forced to use a USB to Ethernet adapter.
On the HP stream, i went into BIOS and Enabled Legacy Support as well as Disabled Secure Boot. Now when i try to PXE boot, it gets hung up at "iPXE Initializing Devices".
I have tried to research the issue with no luck. Any help would be appreciated!!