Posts made by bnstv

@george1421 I must have missed the other persons post, this is my only post about it. Thanks for the info and I will check out that article

Hello,
I have built an image on a Dell Optiplex 5090 and when I try to capture an image PXE boot starts but fails after successfully downloading the NPB file, saying “No Bootable Devices Found”.
Secure Boot and Fast Boot are disabled
I have tried the drive in the default RAID On, as well as in AHCI and had the same results
The image is syspreped as well.

CLI info
NBP filename is undionly.kkpxe
NBP filesize is 98899 Bytes
Downloading NPB file …
NBP file downloaded successfully
TIA!

@sebastian-roth said in Fog http wrong:

port fast

Thank you! I jumped in the switch and enabled port fast and that has taken care of the problem. Thank you for all your help!

@sebastian-roth correct, this has been pxe booting and not done manually through usb. Putting in the dumb mini switch got past that. Thank you!

@sebastian-roth unfortunately I do not get shell after pressing enter. This is what I get instead

@sebastian-roth
Currently running fog 1.5.8 but I do see there is 1.5.9 out. Every time I try to add the picture I get an error that just says error so I put it in a google drive and will link it here

https://drive.google.com/file/d/1NU18ZsnI_dnfn2nFDc4XlhYrx7sel_lG/view?usp=sharing

@bnstv Update:
I discovered where I missed the change for the IP but I am still getting the error just with my new IP address

I am getting the DCHP filed or we were unable to access http://192.168.5.123/fog//index.php but that is the wrong IP. I have checked the /tftpboot/default.ipxe and it is correct in there. I also checked /opt/fog/.fogsettings and it is set correct in there as well. These were suggested in another thread here https://forums.fogproject.org/topic/14025/fog-http-server-not-updating-after-ip-change/5

After changing, I reran the install as well based on the wiki on IP change

Is there a change I am missing?