@Whitespire-tech said in Error code 1326:

1326

That error usually correlates to a bad username/password used. I’d try clearing out the AD account information under fog settings/Active Directory Defaults and re-entering. Make sure you enter the domain in the top box(AD DEFAULT DOMAINNAME) and not by the username in (AD DEFAULT USER).

Also make sure the password you enter in (AD DEFAULT PASSWORD) is not encrypted. The legacy password field is the one that requires encryption and is only for legacy clients.

After you make this change please update the AD settings under the individual host or host group(Click clear fields then uncheck/recheck the “Join Domain after deploy” box so it gets the new settings.

@Whitespire-tech said in Error code 1326:

1326

That error usually correlates to a bad username/password used. I’d try clearing out the AD account information under fog settings/Active Directory Defaults and re-entering. Make sure you enter the domain in the top box(AD DEFAULT DOMAINNAME) and not by the username in (AD DEFAULT USER).

Also make sure the password you enter in (AD DEFAULT PASSWORD) is not encrypted. The legacy password field is the one that requires encryption and is only for legacy clients.

After you make this change please update the AD settings under the individual host or host group(Click clear fields then uncheck/recheck the “Join Domain after deploy” box so it gets the new settings.

As Tom asked, can you get to the web UI?

You don’t by chance have GP set up to add this printer as well do you?

Try setting your menu timeout a little higher, i’m betting these machines or a network lagg are causing the timer to expire before you are shown the menu.

Are you using a custom kernel for FOG?

ipxe does not give time frames for patches or upgrades.

If you want to know if ipxe will work for your machines, try changing your dhcp option 67 to ipxe.pxe and see if your systems work.

You can try searching ipxe’s forum for a supported hardware list and compare your nics to their list.

See my previous post.

I really think you should revert back to undionly and begin troubleshooting from then on. At least that way you can upgrade later without worrying about issues arising due to you still using pxelinux.0.

If you were unable to get past the pxe timeout then your issue is not the same as the linked post so we need to start from step 1 and troubleshoot our way through.

[quote=“Mark Achel Gagalac, post: 37690, member: 26550”]flattered but i don’t think i am qualified. im just an avid fan of Fog and been using it for years. compiled existing how to’s and created my own version that ive tested and known working.[/quote]

I fail to see how anything you just said makes you unqualified to post on the wiki…

Can you upload your fog install log? It is located here:
[CODE]/var/log/foginstall.log[/CODE]