Additional disk space is not showing up on Fog server

[sjensen]

@george1421

Here is what I got. I added around 300gb to the linux vm.

[Tom Elliott]

@sjensen Did you expand the volume?

It may require you to run a live cd to expand seeing as, if I’m understanding correctly, you’re trying to expand the root partition.

While it is possible to resize the root partition live, I’d recommend against it.

If you can create a snapshot of the system before you make any partition changes, I think it may help you out too.

[sjensen]

@Wayne-Workman
Here you go.

[sjensen]

@Tom-Elliott
Its already done. I used Gparted live cd.

[Tom Elliott]

@sjensen I think, then, all you need is

vgextend FOGserver-vg /dev/FOGserver-vg/root

Edited as I copied from another site, and forgot to modify the vg_tecmint portion.

[sjensen]

@Tom-Elliott said in Additional disk space is not showing up on Fog server:

vgextend FOGserver-vg /dev/FOGserver-vg/root

Sorry im still new to linux where would i place that at?

[george1421]

@sjensen linux console…

What may be confusing you is that linux (here) is using LVM (logical volume manager) to manage your disks. It doesn’t have an equivalent in the windows realm. But LVM is an abstract layer between the hardware and the OS. If you close one eye and squint with the other one, one might says its a kind to a disk virtualization layer. Between the hardware and the OS. (even if the system is running as a virtual machine). LVM allows you to add more disks to an operating system without needing to reformat your hard drive to extend it. Granted its much easier now with linux running on a vm to extend the vmdk and add space, when you are talking about physical servers, it a bit harder. That is where LVM comes into play.

[Tom Elliott]

@sjensen Open a terminal.

Gain root: (If ubuntu typically sudo -i).

Once at the root prompt, run the command.

Root prompt looks similar to:

[root@fogserver ~] #

[sjensen]

@Tom-Elliott
ok done

[Tom Elliott]

@sjensen Did it work?

[george1421]

@sjensen now do you see the additional space when you do a df -h ?

[sjensen]

@Tom-Elliott

[Tom Elliott]

Did you expand the originating volume, or did you add a new HDD to the VM?

[sjensen]

@Tom-Elliott

1. i added more disk space from the hyper v console
2. booted into gparted live cd and extended the volumes.
3. rebooted

[Junkhacker]

@sjensen it might be easier to follow these instructions to resize your LVM, you’ve already done part of this, but i’m sure you can figure out what needs to be done yet. https://blog.vbonhomme.fr/extend-a-lvm-partition-after-increasing-its-virtual-disk-on-virtualbox/

[Wayne Workman]

@sjensen I’d also recommend against gparted in this particular case. To do what you need manually it’s only a couple standard linux commands.

[sjensen]

@Wayne-Workman it’s a little late for that Wayne. I’ve used Gparted already. It seemed like a good solution.

[sjensen]

@Junkhacker Would this work for a Hyper-v machine too?

[Junkhacker]

@sjensen your virtual machine doesn’t know it’s a virtual machine, so what hypervisor you’re using is irrelevant. everything in the steps past gparted (which you say you’ve already done) is relevant

[sjensen]

@Junkhacker Thank you for the link. If I understand this correctly, gparted resized the partition, now I have to go in and make changes so Ubuntu sees that I extended the hard drive space. Is basically what needs to happen? Please bare with me I am new to Linux, i’m still learning. Any advice is appreciated.