All fog services turning off on hosts after reimage.
-
@Raymond-Bell Yes they are all enabled by default, and they are enabled prior to pushing the image to the machines, however they all get unchecked specifically for the machines I imaged.
-
Has anyone experienced something similar to this? I just upgraded to 1.3.5-RC1 and the issue is still there
-
Did you check fog.log?
-
Hi,
I am expiring also the same issue, and was wondering if any one has found a answer for this issue
Server
Fog 1.5.0.16
OS Centos 7Client
Service Version 0.11.15
OS Windows 10 1709 Education -
It happens to me as well, but so far I would have assumed that I just forgot to activate the service settings for the machines where it happens, but it does happen quite often.
FOG latest RC
OS Centos 7
Images being installed are Win10 - 1709 -
@taspharel Just for clarity (since the OP is talking about a down level version). After imaging, in the setupcomplete.cmd file, you use the sc command to enable the fog client service, then you manually start the service. After a reboot the service is not restarting? Where exactly is it failing? I do remember reading a discussion about setting the service to delayed start instead of auto. I’m not sure that applies here. But the developers will need to understand exactly where its failing.
-
@george1421
In my case de services is running oke on the client.
The issue remain on the fog server, all the client settings are checked before imagine a computer and after imagine the computer (or again) all the client setting are unchecked. in the fog GUI “Client Settings”
If manually checked again after imaging, then the client will apply the client settings and reboot.
and everything is working oke.Just noticed the the current power management settings are also gone after re-imaging
-
@pijltje said in All fog services turning off on hosts after reimage.:
In my case de services is running oke on the client.
The issue remain on the fog server, all the client settings are checked before imagine a computer and after imagine the computer (or again) all the client setting are unchecked. in the fog GUI “Client Settings”
If manually checked again after imaging, then the client will apply the client settings and reboot.
and everything is working oke.@Developers This one is a bit strange, image deployment resets Host Management-><host>->Service Settings in FOG 1.5.0. Is this a new feature
-
Hi,
i also have seen this behaviour, i cannot say exactly with or since which version this happened.
But i can remember that i deployed a client and i was wondering that the task wasn’t finished as expected.After head scratching i could see that all the services where not enabled (normally they are active by default).
Regards X23
-
@george1421 Sorry, I mixed up terminology there.
The Fog-Client-Service runs just fine (i use setupcomplete to enable it and then start it, and yes it is set to delayed start, but that usually works out fine somehow.
I’m talking about the service settings in the fog webgui.
-
Hi,
something additional, today i registered a host, enabled domain join and a snapin like i always do. deployed the image and was wondering why the host hasn’t joined the domain. After checking the hosts settings i could see that joining domain wasn’t saved for this host. enabled it again and the host joined the domain and rebooted.
I don’t know if this is related but i have the feeling it could.
Regards X23
