image capture ipxe error input/output 1d0c6139

[KnightRaven]

@Wayne-Workman
Yes. Had to to match our new subletting rules. Followed the steps to change it from the wiki in fog.

[KnightRaven]

@KnightRaven
Would the imaging be defaulting to using multicast? I’ve heard some other techs report problems with multicasting using Ghost. But unicast seemed to work ok.

Ghost has been our standard but it’s an older version. Been trying to setup fog for myself and test it to give an alternative. Been going good til this subnet change. If I can’t get help from our networking side for it to talk across the subnets it may be a bust.

[Tom Elliott]

@KnightRaven is the fog server on a different subnet than the host requesting access?

[KnightRaven]

@Tom-Elliott No. They are in the same room and same subnet.

[KnightRaven]

@KnightRaven @Tom-Elliott @Wayne-Workman
it looks like it may be a multicast issue, if Fog defaults that way. Just heard that the multicast settings haven’t been pushed with the new subnets. Or so I’m told

[Wayne Workman]

@KnightRaven said in image capture ipxe error input/output 1d0c6139:

@Wayne-Workman
Yes. Had to to match our new subletting rules. Followed the steps to change it from the wiki in fog.

duh. Read, Wayne.

So, after setting the right IP in /opt/fog/.fogsettings you then run the installer. Is that what you did? Also - it’s fine to re-run it again.

[KnightRaven]

@Wayne-Workman
Yes, exactly. I think I checked the settings in fog first. I went to the fog settings -> web and tftp settings in the webgui and changed it there first. But I did change the .fogsettings file and then re-ran the installer.

The last couple of updates it didn’t prompt for a schema update when opening the webgui after installing update. Just went straight to login. Not sure if that matters. or is as designed in the RCs.

[Tom Elliott]

@KnightRaven Well, the only reason “multicast” would need to be enabled is for the initial TFTP boot, after that it’s using HTTP (TCP).

[Wayne Workman]

@KnightRaven if you visit that boot.php url, what do you see?

[KnightRaven]

@Tom-Elliott
OK.
Well, I think I figured it out. I may have missed updating the storage node info. The graphs/pie charts are back working now.

Setup capture and is working. Ugh. the one thing I didn’t double check after it all. Being that its the only storage node I didn’t think to check it again.

Thanks for all of y’alls time. sometimes it just needs more eyes and a better understanding of how this works. Y’all have a great day. I need a beverage.

thanks,
Jason