Pxe not working after update



  • Hi

    I recently started making a image of one of my machine types I performed a full inventory of the machine and it appears in the hosts list.

    since then I updated fog to 1.2.0 from 1.1.2 and I have come to upload the image made the task in the web gui for the host and when I pxe the machine it picks up the machine ip dhcp etc but tftp fails and pxe aborts.

    any ideas?



  • thanks I will make the change and test.



  • In Ubuntu 12.04 and later the tftp starts to soon after a reboot. I have had good success with doing the following.

    sudo gedit /etc/rc.local

    then add the following line
    /bin/sleep 30 && /etc/init.d/tftpd-hpa restart



  • is there a permanent fix for this just had to restart this service again.



  • Cheers jaymes should of looked harder before posting.


  • Developer

    [quote=“chclark, post: 34006, member: 6419”]Ubuntu 12.04 lts.

    But got it working now saw another thread mention similar but not the same and they were advised to restart the tftpd-hpa service once I did this it loaded correctly and started the upload job.[/quote]

    That’s where I was heading just wanted to make sure to get you the right command ;)



  • Ubuntu 12.04 lts.

    But got it working now saw another thread mention similar but not the same and they were advised to restart the tftpd-hpa service once I did this it loaded correctly and started the upload job.


  • Developer

    What Version of linux did you install FOG on?


 

341
Online

41.6k
Users

12.1k
Topics

114.4k
Posts