Fog 1.1.1 - Fog boot menu and Image download exits
-
When you say the system gets: “download : operation not supported” what is the exact error message? Is it 040e119?
On your network, do you have Spanning Tree Protocol enabled on your switches? This is most likely the cause for your Operation Not Supported error. My guess is this is probably what’s causing the problem with full host registration as well.
-
Hi Tom,
Thanks for the prompt response.
The error is - "Could not boot : connection timed out ([url]http://ipxe.org/4c0a6035[/url]) "
(This error come after selecting full host registration - It loads bzImage and this error comes and exits)Yes spanning tree is enable in the switch.
Thanks&Regards,
Siva -
Can you disable spanning tree, I believe you’ll have much more success with getting IP information.
-
Hi Tom,
Here spanning tree is must for some network requirement it seems and I don’t have access for the core switch to test it. I am help less now.
Yeah I am getting IP from DHCP Server.
Thanks&Regards,
Siva -
If these are Cisco switches, might you be able to enable “PortFast”?
-
Hi Tom,
Its all Juniper Switch.
-
-
Thank you once again for your great support.
Please let me know what are the things has to be done on the Juniper switches by following the link you have shared.
Regards,
Siva -
Hi,
Can you please tell me the change in settings that should be made on the switches for FOG.
Regards,
Siva -
[quote=“Sivasubramaniam.T, post: 30763, member: 22852”]Hi,
Can you please tell me the change in settings that should be made on the switches for FOG.
Regards,
Siva[/quote]Siva, I don’t have any Juniper switches either at my workplace or at home to do test settings with. I found this documentation to help you with getting the proper setup.
-
Ok, No Issues bro. I will try with different possible ways to fix this and let you know. Thanks for your support.
