Downgrade to 0.32
-
Any suggestions or anything or am I out of luck and need to wipe my FOG server and start over from scratch?
-
I’d recommend exporting your hosts table from 1.1.0, then uninstall FOG Completely by deleting the FOG Database.
Install FOG 0.32 as you normally would, and perform the database update on the browser. Once that’s all complete, reimport your hosts. You’ll have to set the hostOS on the host once again, and recreate your images according to your setup. But once that’s done you should be good to go.
-
I did follow your steps on the formatting the drive bit but I noticed even after that if I run the compatibility test I get this message.
Error: Can’t have a partition outside the disk!
Under the results it shows Network and Disk as pass. I’m really not wanting to recreate these 7 images lol -
The image that you already have, what was the size of the hard drive you created the image on? Is it larger than the size of the disks you’re trying to put the image on?
The “Can’t have a partition outside the disk” usually means you created the image from a larger disk than what that particular drive can actually have.
-
No they are all the same size they deployed fine last summer and I haven’t made any changes since besides updating FOG.
-
I just checked and yep it is bigger is that some kind of bug with the new version of FOG?
-
When trying to image, is it set as Partimage or Partclone?
Have you tried changing the type to Partimage if it’s not set?
-
Yeah, it’s set to partimage.
-
It must be the drive size thing. I just went and tried to image one of my 320’s and it is working. So I’m only going to have to recreate my two 755 images. Praise baby Jesus! lol
-
before you do that just try change the value of FOG_UPLOADRESIZEPCT to 15
It is in the general settings.I seem to remember we had the same problem, a couple of years ago.
