10th Gen NUC BXNUC10i5FNK1 Drivers Kernel
-
@george1421 Did Option #1 and worked perfectly. Again I appreciate you responding and the effort put into this IT infrastructure tool.
-
@george1421 I’m trying this method option 1 with my NUC10i3fnk1, and it gets past loading bzImage5618 and init.xz and hangs without moving forward. I’m on version 1.5.9 of FOG. I feel so close but so far away on this. Thanks for any help you could provide.
-
@ccfrederick said in 10th Gen NUC BXNUC10i5FNK1 Drivers Kernel:
it gets past loading bzImage5618
Understand its now a year later…
What I would do in your case is to use the FOG Configuration->Kernel update utility to upgrade to FOS Linux 5.10.x and then make sure you set back the default kernel to bzImage and bzImage32. The dev image bzImage5618 was a temp kernel until the linux developers released the next LTS version of linux, which ended up being 5.10.x.
-
@george1421 Thanks for the reply on such an old thread! I have already tried 5.10 with no success, unfortunately. After doing some digging I found an official hardware list that only includes a few Intel NUC chipsets, so it would appear that this is dead on arrival for me. Too bad as I really like Fog as an imaging solution. Thanks again for your help!
-
@ccfrederick said in 10th Gen NUC BXNUC10i5FNK1 Drivers Kernel:
only includes a few Intel NUC chipsets, so it would appear that this is dead on arrival for me. Too bad as I really like Fog as an imaging solution. Thanks again for your help!
We are far from dead in the water. First make sure the firmware is up to date on the nuc. The problem seems to be the hand off from ipxe to FOS linux. If this is the case we can bypass ipxe and boot directly into FOS Linux. There are some caveats with this approach as well as you lose some functionality (like multicast imaging). But for unicast imaging booting into FOS Linux will work just fine.
-
@ccfrederick Disregard the last message, I was installing the wrong 5.10 kernel. I grabbed the standard 64bit 5.10.34 and all is well. Hope this helps someone!
-
Hi there,
I’m having issues booting into the fog menu with both UEFI and Legacy
can you reccomend a kernel to use for
Intel NUC10i7FNHThanks
-
@chris_unit I just went into my FOG Gui, clicked Fog Config->Kernel Update->Kernel 5.10.50 Tom Elliot 64(Third One I think) and then I clicked Download on the right. It installed. I rebooted for good measure and all worked.
-
@dangbird Thanks for the tip
i’ve now done the same, do i now have to specificy that kerner for my NUC’s in the hosts info (bzImage)
Is this kernel both legacy and UEFI ?
-
@chris_unit As long as it is default NO. Otherwise you have to change it to bzimage and bzimage32 in fog system settings TFTP Server
