MULTICAST exit code 1 (write image) PARTCLONE FOG v1.5.4.8

[Gatou]

Bonjour,

I’ve add MULTICAST ADDRESS and a MULTICAST RENDEZVOUS in Multicast Settings in FOG System Settings WEB GUI because before my PARTCLONE Client was freez at start.

It Work 1 time and then i restart my FOG server and it display this error screen on PartClone:

I have no partclone.log

[Sebastian Roth]

@Gatou Check your firewall settings: https://forums.fogproject.org/topic/8743/can-not-deploy-using-multicast-read-image_hdr-block_size-error

By the way, usually you don’t need to change those multicast settings at all! Better to look into your firewall and switch configuration.

[Gatou]

@Sebastian-Roth Thanks but i didnt install Firewall. I have Ubuntu 16.04 LTS.
I Disabled all i can.
How can i see if a Firewall is enable somwhere ? Something pre-installed maybe? And I directly connect with an ethernet into my fog server.

[Sebastian Roth]

@Gatou Run sudo iptables -L -n -v and post output here.

[Gatou]

@Sebastian-Roth

administrateur@FOG-SERVER:~$ sudo iptables -L -n -v
[sudo] Mot de passe de administrateur : 
Chain INPUT (policy ACCEPT 0 packets, 0 bytes)
 pkts bytes target     prot opt in     out     source               destination         

Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
 pkts bytes target     prot opt in     out     source               destination         

Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
 pkts bytes target     prot opt in     out     source               destination         
administrateur@FOG-SERVER:~$ 

[Sebastian Roth]

@Gatou Ok, firewall on your FOG server is disabled indeed. But maybe there is a firewall or router or layer 7 switch between your FOG server and the client?!? What does your network setup look like?

[Gatou]

MY BAD ! @Sebastian-Roth

It’s because i have to be precise on the session creation fileds.

I have to put exactly the number of clients ?

When i was create session ive put timeout time…

So it work but after the timeout…

Sorry thanks for ure help anyway