MULTICAST exit code 1 (write image) PARTCLONE FOG v126.96.36.199
I’ve add MULTICAST ADDRESS and a MULTICAST RENDEZVOUS in Multicast Settings in FOG System Settings WEB GUI because before my PARTCLONE Client was freez at start.
It Work 1 time and then i restart my FOG server and it display this error screen on PartClone:
I have no partclone.log
MY BAD ! @Sebastian-Roth
It’s because i have to be precise on the session creation fileds.
I have to put exactly the number of clients ?
When i was create session ive put timeout time…
So it work but after the timeout…
Sorry thanks for ure help anyway
@Gatou Ok, firewall on your FOG server is disabled indeed. But maybe there is a firewall or router or layer 7 switch between your FOG server and the client?!? What does your network setup look like?
administrateur@FOG-SERVER:~$ sudo iptables -L -n -v [sudo] Mot de passe de administrateur : Chain INPUT (policy ACCEPT 0 packets, 0 bytes) pkts bytes target prot opt in out source destination Chain FORWARD (policy ACCEPT 0 packets, 0 bytes) pkts bytes target prot opt in out source destination Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes) pkts bytes target prot opt in out source destination administrateur@FOG-SERVER:~$
sudo iptables -L -n -vand post output here.
Gatou last edited by
@Sebastian-Roth Thanks but i didnt install Firewall. I have Ubuntu 16.04 LTS.
I Disabled all i can.
How can i see if a Firewall is enable somwhere ? Something pre-installed maybe? And I directly connect with an ethernet into my fog server.
@Gatou Check your firewall settings: https://forums.fogproject.org/topic/8743/can-not-deploy-using-multicast-read-image_hdr-block_size-error
By the way, usually you don’t need to change those multicast settings at all! Better to look into your firewall and switch configuration.