UEFI PXE boot
-
@george1421 Then in the policy for the scope in question (could also be a global scope, but make sure you don’t have any local overrides) your polices should be set up similar. Just be aware you will need one policy for each vendor class you setup. Here is an example of one.
On the conditions tab you setup what to match in the packet
Then on the options tab, you need to set dhcp option 67 to the boot file you need. In this case its ipxe.efi.
-
-
@tesparza Well OK that one looks perfect. What about the policy now? Will you post images from the tabs I referenced below?
-
-
@tesparza While this is a bit off point, the dhcp 66 options for each policy is a bit redundant since you are not changing the boot server based on each policy, you only need to change the boot file name.
-
-
-
@tesparza Well that’s disappointing, because you have it setup correctly.
So why is not the policy matching in the scope??
-
@george1421
thats the server options within the scope for this particular hall im in. -
@george1421 It worked the policy was disable on each scope and the secure boot on enable, just had to activate the policy and and disable secure boot
