@george1421 Target is UEFI, image was captured in Legacy VM. Will try again with VM in UEFI mode

Hi I created a based Master image in VirtualBox using VHD as storage option. I did all I need to do to the image and I sysprep it. I captured the image into FOG and the image is there. I tested the image by deploying to a computer but when the computer finishes imaging and it reboots. It does no boot. I look in the BIOS and I see that the Boot Option are just ipv4 and ipv6 no hard drive is there, the image deletes the HDD boot option? What can be causing this issue?

@sebastian-roth Yup its was, “Is Graph Enabled (On Dashboard)” Working now. thanks.

Been running into this error where host registration, capture, or deployment is errored out when Bios in Dell device for example is set to storage mode Raid On. Once i switch to AHCI it works. Is there a way for it to work either way?
Also secure boot option. Is there a way for device to trust FOG pxe boot?

@sebastian-roth will check it out tomorrow, we were on break. I will let you know.

Hi the GUI web interface is not showing Storage nodes even though the are added under storage tab.

@sebastian-roth
Okay will check. Also when installing the Smart Installer client, what IP do i put. The main fog or the Local storage node?

Hello, I just added my first Storage node and the images on my main FOG have the replication check box (checked) but how do I know when that have transferred over to the storage node?
Second question, On the main FOG dashboard under the Storage Node Disk Usage the drop down box doesnt show the new storage node even though when you go the Storage Node tab node is listed.

@wayne-workman Yes thank you, video answer alot.

@george1421 Okay, each storage node has their individual IP address. Thanks.