Unsolved After capture, Windows won't boot

[bigchief]

Hey,

Not sure where to go next. I have wasted a lot of time trying to change settings and no luck.
I put together a newer PC, MSI z370-A Pro motherboard with an i3 8100 and SATA SSD. I installed Windows 7 Pro 64 and trying to capture the image, like I always do, but once it finished, something breaks and Windows won’t boot. I get a blinking white line.
I’ve tried to deploy the image to the machine but same thing.

Are there logs or anything I can check to see what’s going on?

Fog 1.4.4

[Wayne Workman]

@bigchief Sounds like a mismatch of bios/ueif to me. A UEFI system can sometimes have the feature to optionally legacy boot (bios). What mode is the firmware in? (bios/legacy or UEFI)? So figure that out - and then dig through the firmware settings to make sure no optional Legacy modes are enabled.

Also, could be something as simple as turning off the HDD’s RAID mode in firmware and enabling AHCI mode.