Virtualbox PXE Boot - No configuration methods succeeded

[Tom Elliott]

@austin_g Is the VM setup with a “NAT” nic or “Bridged” nic?

What’s providing DHCP to the VM?

[austin_g]

It’s configured as Bridged, as shown in the first screenshot.
The FOG server is handling DHCP. It appears to be assigning IPs correctly, and the next-server is set to the FOG server ip. There aren’t any other DHCP servers on that subnet.

[Tom Elliott]

@austin_g just because it’s booting to ipxe does not mean it should work. What boot file are you using? In the past I had to use ipxe.pxe for virtual box to work consistently. Of course other factors could cause the problem I suppose.

[austin_g]

I’m fuzzy about that part. I see class definitions in the dhcpd.conf that FOG installs that matches against vendor-class-identifier. I’m not sure what the vendor class identifier for virtualbox would return, but looking at the dhcpd.conf, there is no default option that it would select? I’ll try setting ipxe.pxe explicitly without the class matching.

[austin_g]

Setting it explicitly and removing the class matches did the trick, I got into the boot rom. After that, I coped back the old config, and replaced the Legacy class match filename with ipxe.pxe, and that worked also.

Thanks!

[Hanz]

@austin_g IPXE.kpxe is needed now for VMs as this wasn’t always the case. I’ve found that recently i have run into this more frequently as of late. That (I can confirm) is the only change necessary for sure pxe boot with Virtualbox VM. Probably on Virtualbox’s end I’d imagine given the timing.

[sandervg]

I am facing the same issue as mentioned here. With a small difference. PXE boot is working perfect on a cold boot. But when I restart my vm I get the error that no configuration method succeeded. Using ipxe.kpxe is a solution for my virtualbox vm’s but causes physical computers to stop working. I guess the best option would be to match the UUID of my vm’s in my dnsmasq.conf and send the right PXE file. But in the syslog i can only see part of my client-machine-id. Any ideas on a good solution for my problem? vendor class: PXEClient:Arch:00000:UNDI:002001 this is the same for all my machines so I can’t switch on thath.

[george1421]

@sandervg said in Virtualbox PXE Boot - No configuration methods succeeded:

PXE boot is working perfect on a cold boot. But when I restart my vm I get the error that no configuration method succeeded.

FWIW: I also see this in my dev environment. Its an issue with virtual box and not your environment. When this happens I just have to power off the vm to do a cold boot. It not the answer you were looking for, but I just wanted you to know its not a unique issue.

[Tom Elliott]

@george1421 I’ve seen this too though the fix for me was to use ipxe.pxe with VB and no more issues with warm boot failing.

[george1421]

@Tom-Elliott said in Virtualbox PXE Boot - No configuration methods succeeded:

I’ve seen this too though the fix for me was to use ipxe.pxe

Just for clarity, you are using ipxe.pxe from the fog /tftpboot directory replacing the VBox version/file? This resolves the issue?

[Tom Elliott]

@george1421 I’m using ipxe.pxe as the boot file. Not replacing the version VB’s NIC’s are set too. (Though I imagine that would work well too.)