All know hosts show as pending when a new host shows as pending.

[Hanz]

I have a script that @Wayne-Workman wrote, that shows pending host as they come in. I noticed that when a host comes in as pending…all previously accepted/known hosts show as pending as well. When I manually add the host from the list in the log output from said script, all host disappear from pending and all looks as it should.

18/03/2016 10:54:02
 
Pending Hosts:
3557	dmNew1
 
Number of Approved Hosts:
1756
 
Number of Total Hosts:
1757
 
Number of Total MAC addresses:
3558
 
uptime Output:
 10:54:02 up  2:11,  2 users,  load average: 1.00, 1.26, 1.40

I reset the encryption keys after deleting all hosts and adding again from the old database backup from 6549.

the host dmnew was manually set to pending, which shows correctly; however all hosts without a key are showing back up under pending hosts. This has happened since updating to 6777 from 6549. and now I’m currently on 6815.

When I accept the pending hosts listed from output of script, all goes back to normal

[Tom Elliott]

Confirmed, Found, Fixed, and pushed (ONLY THE PART WHERE CLICKING PENDING HOSTS SHOWS ALL HOSTS).

THey should not all show up as pending though. This was a mistake in coding. I copied a prior entry (in the search area) to the pending area and forgot to make the change as necessary.

[Tom Elliott]

@Hanz Based on my finding, everything was working fine.

Number of MAC’s 3558 (I’m guessing there’s two macs that were added for dmNew1 host).

Number of approved hosts = 1756.

Number of Total hosts = 1757.

Based on that, (1756 Approved + 1 Pending) = 1757. Is this incorrect?

[Hanz]

@Tom-Elliott thanks to you and Mr. Workman…I would have had no way to know which host was showing as pending if it wasn’t for his script.