Partial image uploaded to fog

[My Sanity]

Sure can, check it below:

[Wayne Workman]

Then it’s something else… I’ll re-read through this when I get home.

Thanks for clarification… I’m not trying to be mean or anything but… people who come here for help… they come in every flavor, personality, skill level, level of consciousness… lol. I have learned to not assume.

[My Sanity]

@Wayne-Workman I hear you on this load and clear. And you are totally fine, no offense taken. I work with helping people with computers at a bank (that are not the most tech savvy users), so I can relate to you and most of us normal users in Fog

If we can’t find a fix for this, its fine. I don’t want to take up a lot of folks time on here, because we can always just start from scratch again if needed. We had some major issues with our past installation (including me managing to change a few things in a few places I wasn’t supposed to…opps lol)

[Wayne Workman]

Did you try Multiple Partition - single disk - resizeable yet?

What model of machine is this happening on, or is it happening on all machines?

Is the image MBR or GPT ?

[Tom Elliott]

I’m confused. What is the problem? Does the image work? File size on server should be less than what the file size for the client should be because we compress the image as it is being uploaded. Partclone only copies used blocks, not free blocks too. This is why the data block size is typically ahead of the total size. They are two completely separate things. Total block means all the blocks of the disk, data blocks is only the used blocks. So on a typical system with an 80 gb hdd and only the windows operating system installed, you may have used about 12-18 gb of the full value of the hard drive. This just a simple example to give understanding. So when you upload the image the total block size is representative of the whole disk of 80gb. While the data block size is only representative of the 12-18 GB of actually used data. Even in resizable this is shown as the volume is shrunk to just larger of the used block size.

[Wayne Workman]

@My-Sanity said:

When I go to deploy this image to another client, it appears to image normally, but after the reboot it boots to a blank screen with a blinking cursor.

[My Sanity]

Update on this.

@Wayne-Workman, the image is MBR. I don’t have an option for Multiple Partition - Single disk -resizeable.

And the machine(s) is/are custom build desktop machine(s) (Intel/Asus board). (Note: this was before my time when they got the machines).

[Wayne Workman]

@My-Sanity Sorry, I meant single disk - resizeable.

The only one that is resizeable lol.

[My Sanity]

Wayne, I will start the image tonight and check it in the morning (seeing that it takes an hour + to upload), try to deploy it, and update the post with what I find.

[My Sanity]

Update:

The single disk resizable seems to be working. I have successfully imaged two computers of various disk sizes and it works.

I guess from my knowledge (issues and experience) with Fog .32, I never used single disk because whomever was before me used multiple partition image. It is also good to know that the image is compressed when sent up to the server. I probably read it somewhere but glazed over it.

I think if I have any problems here on out I will update.

Thanks @Wayne-Workman and @Tom for your assistance, it is much appreciated