Fog issues with DELL Optiplex 3020

[Tom Elliott]

Cody,

DLC writes that when he followed the instructions properly, all was working finally.

Please see the FAQ link in the signature as it should help you out if done properly.

[need2]

But FAQs are hard.

[Cody Lee]

Tom,

Copied the commands directly from the WIKI and still getting Kernel Panic errors.

Thanks,
Cody

[Jeffery Harrell]

Tom I used everything you said to do with new kernel & I am running .32 still & it worked on a 3020. It takes a little bit longer for it to start to register, but that’s better than nothing! Thanks!

[alainstar]

Hello, I have a problem with a drive dell optiplex 3020. not start.The red LED on the motherboard lit but when I press the power button does nothing. Can you help me please ?

[Tom Elliott]

[quote=“alainstar, post: 35251, member: 25610”]Hello, I have a problem with a drive dell optiplex 3020. not start.The red LED on the motherboard lit but when I press the power button does nothing. Can you help me please ?[/quote]

This sounds more like an issue with your motherboard, not an issue FOG or any of us here on the forums could help you with.

[Phillip Goble]

I am have the same trouble with my fog server, I did the kernel update but it still is hanging. I did the cp of the bzImage and more suggestions.

[Tom Elliott]

[quote=“Phillip Goble, post: 40656, member: 28105”]I am have the same trouble with my fog server, I did the kernel update but it still is hanging. I did the cp of the bzImage and more suggestions.[/quote]

Confused by what you mean.

Is it hanging indefinitely, or your patience just wearing thin?

[Phillip Goble]

Hanging indefinitely, or do I need to update my version of fog. I am using 0.38. and help would be greatly appreciated.

[Phillip Goble]

I will check log file as well. Phillip

[Phillip Goble]

I finally got it to register but now I am getting the error message more than 2 partitons any suggestions. Phillip

[Greg Gaspard]

I’m running into the same problem.

Using Fog 1.2.0
Optiplex 3020, BIOS A05
No matter which kernel I use (official or unpublished) I can’t upload my image.
It gets stuck at “Using Hard Disk: /dev/sda”

And really, only kernels 3.14.2 and 3.16.0 have let me get this far. I let it go an hour yesterday hoping it would work but it just freezes at this point.

Any help would be appreciated.

Thanks