Windows 11 | 65x HP Z2 Tower G1i | UPDATE -

[kratkale]

This post is deleted!

[kratkale]

@Tom-Elliott
clonzilla started
Gained “root” privileges using sudo su
Ran lsblk -pdno => BNE7N774610407R40 identified as the system disk.

Entered into the FOG GUI

An attempt to clone the device results in the following error

Even deleting the PC from the database and adding it again did not solve the problem.
I’m not in the office right now or tomorrow, so I won’t be able to check the debug mode until Monday.
So far, this has happened with exactly one PC (I haven’t tried cloning the other 38 PCs yet). I followed the exact same procedure for the 23 devices I’ve already cloned, and everything works fine on those. This error has only occurred with PC115CAD so far.

[Tom Elliott]

@kratkale the last 0 is an O (ohhhhh) not a 0 (zero)

[kratkale]

@Tom-Elliott

yes - you are right …

[Tom Elliott]

@kratkale Did changing the serial on the host in question get it imaging to the right drive?

[kratkale]

@Tom-Elliott
I was for a coffy - when I came back …

[Tom Elliott]

@kratkale If you update the the latest verison of working-1.6, does this error go away?

[kratkale]

@Tom-Elliott
This bar is missing in multicast Task

[kratkale]

@Tom-Elliott
it works the single Cast with PC115CAD - it was tho old 0O problem thanks

No errors with database and so on - like it was in multicast - reported …
fog client will now be installed after cloning - first try

[Tom Elliott]

@kratkale

I’m using a simulation but I’m still seeing percent for mutlicast tasks.

[kratkale]

@Tom-Elliott

Now there is the bar …

Error after multicast session:

Installation of fog client worked

Here the used script:

Still Problem with security token

Reset Encryption Data for PC111CAD
working

Tomorrow I’ll reset Encryption Data during the cloning process …