Booting MDT 2013 LiteTouch with FOG
-
@george1421 that was my error.
I copy wimboot file from its directory to /var/www/html and it works.Thanks a lot
-
Hello
How could I had a password to limit access to this wim boot item in boot menu ?
-
This post is deleted! -
Hi,
on my systems these methods works with only Legacy BIOS.
Could you indicate how starts the same wimpe systems with pc that have only BIOS Uefi ?Note: for windows 10 o.s. installed on PC’s with UEFI BIOS the Bios show the option “Windows BootManager option” for start from first HD
Regards
-
@zingaro TBH I have never tried in uefi mode.
As for your note: if these are dell computers, when in uefi mode you need to enable the uefi network stack (on the network page) in the firmware. I assume other OS will have similar options. On the boot options, it will only show valid uefi boot sources so you do need to enable the uefi network stack for that option to show up.
Your MDT boot image should contain the uefi boot kernel. In my case we use VMWare and boot our target computers directly from the mdt iso in uefi mode. They boot without an issue, but again I’m not sending the iso image across the network with pxe.
I can confirm uefi booting via pxe works with these instructions tomorrow since I’m out of the office today for training.
-