I’m pretty sure it’s not either but I just don’t want to miss something.

If it was constantly that slow yeah, but why nothing going on for a few seconds then a bump ? And why did it work 4/5 times faster at the start ?
If I had to wait 30/40 min to image a computer frankly I wouldn’t mind. But now it’s been imaging for 5h40min and it at 87%. I’ll just let it finish to see it it atleast works.

I would like to get it running pretty well then maybe think about getting it setup on a physical host, but we don’t have any to spare right now so it may take awhile to test it.

Anyway, thank you for your input, much appreciated

Edit : Here’s a capture of the traffic on the web interface : [url]http://i.imgur.com/bqWRgik.png[/url]

Hi,

Specs :
Ubuntu 12.04 (VM via VMWare)
1 Single Core i3 CPU (just for now, gonna upgrade if needed)
1GB RAM
200 GB SCSI HDD

Image :
2 Partitions :
One 140GB partition on a 450GB total disk
One 10 GB recovery partition (maybe I should just no touch this one at all but I’ll figure that out later)

I’ve been trying to use FOG for a few days and I’ve run into a problem.

After finally being able to set it up and upload my image, I just tried to deploy one today. Deploy was ok running over 1 GiB/min (pretty slow I think ?). I thought i’d let it run during lunchtime but when I got back (2 hours later) it was around 55% and around 400 MiB/min (constantly decreasing).

Checked on the web interface, at first it was a constant 10MB/S traffic on the graph, now it’s oscillating between 0 and 2 MB/S on and off.
There’s nothing happening for a few second, then there’s a 2MB/S bump, then nothing again etc…

Network’s not bloated, we dont even have 50 workstation on the network and no important traffic going on.

Did I forget to do something or maybe did something wrong ?
I’ll try to debug this tomorrow but I figured maybe it happened to somebody already. Been searching the forum and the web, saw nothing remotely similar to this.

Do you have any ideas ?

Thanks