If you are unable to access the “active tasks” page in your imaging system and need to terminate the tasks from the terminal, you can use the following steps:

Open the terminal on your system.

First, try using the “killall” command with the “udp-sender” process again:

code
killall udp-sender
If the “killall udp-sender” command doesn’t work due to ongoing transmissions, you can use the more forceful “kill” command followed by the Process ID (PID) of the udp-sender process. To find the PID, you can use the “pgrep” command along with the process name:

code
pgrep udp-sender
Once you have obtained the PID, use the “kill” command to forcefully terminate the process:

bash
code
kill -9 PID
Replace “PID” with the actual Process ID you obtained from the “pgrep” command.

Please note that using the “kill -9” command is a more forceful way to terminate a process and should be used with caution. It forcefully ends the process without giving it a chance to clean up or complete any ongoing tasks, which may lead to potential data loss or other issues.

Before using the “kill -9” command, ensure that terminating the udp-sender process won’t cause any adverse effects on your imaging system or ongoing tasks. If you are uncertain or facing any critical issues, it’s advisable to seek assistance from your system administrator or technical support.