Hi Tom, couldn’t try it as the user needed the new pc immediatly, will try again when I get a new m93 in
I also run into trouble on a lenovo x240 now… ‘unknown unclaimed register before writing to…’

[quote=“Chris Sodey, post: 20979, member: 1418”]I have tried Toms 3.12.4 kernel with the same hanging problem. I have attached a screen shot.[/quote]
Hi
I get the same with a Lenovo X240…

also tried it with [URL=‘https://mastacontrola.com/fogboot/kernel/bzImage’]https://mastacontrola.com/fogboot/kernel/bzImage [/URL]
[URL=‘https://mastacontrola.com/fogboot/kernel/bzImage’]which gives two lines then hangs[/URL]
[URL=‘https://mastacontrola.com/fogboot/kernel/bzImage’][/URL]
thanks
best regards
Oli

Hi,
I just received a fairly new desktop Lenovo M93p,
I have the latest 3.88 kernel installed
and receive this:

tps65010: no chip?
acpiphp_ibm: ibm_acpiphp_init: acpi_walk_namespace failed
cr_bllcd: INTEL CARILLO RANCH LPC not found
Could not find Caruillo Ranch MCH device
uvesafb: failed to execute /sbin/v86d
uvesafb: make sure that the v86d helper is installed and executable
uvesafb: Getting VBE info block failed (eax=0x4f00, err=-2
uvesafb: vbe_init() failed with -22
drm/i810 does not support SMP
[drm:i915_write32] ERROR unknown unclaimed register before writing to c5100
i915 0000:00:02.0: More than 8 outputs detected

Let me know,
Much appreciated!
Best regards
Olivier

I took the WD harddisk from one of the GX745’s that worked, put it in the GX755 that has the issue, then reimaged with the same image, works fine; I then took the Seagate harddisk that was originally in the GX755 and put it in the GX745 and tried to reimage, and it works as well…go figure, am totally confused as to why FOG images the Seagate fine in the GX745, but not in the GX755…

repair didn’t work, chkdsk didn’t work,
but I have noticed that during the imaging of the second partition, it cuts off at 20-21 % (it varies)… which probably means that not all data was restored from the image,

Hi,
I have the same issue just today, also a multiple partition single disk setup, with 100MB for the Windows 7 diagnostic partition, 25GB for the OS (the actual drive) and the rest on a third partition (the drive) , this only seems to happen on a Dell GX 755 (bios A19); the same image works fine on all my other GX models (380, 760, 745, 520, 620…),
running the W7 repair doesn’t work, am now running a chkdsk and it seems to be deleting a lot of stuff…