[quote=“MikeyMike, post: 1288, member: 493”]I apply SP1 as an offline installer (you also get an extra count to 4 re-arms total if you do this) and I also apply all windows updates to the image before uploading and its always worked with various Dell, HP and Acer laptops and desktops on my school network. I run checkdisk, ccleaner also and then defrag about 4 times before an upload image. I still run fogprep and dont have fog client installed and havent seen the issue you have mentioned at all. Hope that helps![/quote]

[quote=“andyroo54, post: 1292, member: 267”]I don’t get that error with SP1? My SOE has SP1 and I haven’t had any probems with .32[/quote]

Ok thx guys! I will retry next week and if that doesn’t work , i will create a new post in another subject.

[quote=“MikeyMike, post: 1275, member: 493”]I dont see any issues with Windows 7 64 bit. I have been using it since Jan 2010 with Fog .30 and now .32. I work with over 300 Windows 7 64 bit computers and I have never used sysprep. I dont have any issues with kms either I just make sure my image doesnt join the domain until after deployment.[/quote]

Without windows updates, i have no problem too.However with the SP1 and more of w7, i can’t create a new image (i received “****” at state “check disk”…

Very great job for the last versions.
Is the next version going to take care correctly Windows 7 one 64 bit(by avoiding sysprep and co)?
Otherwise I will be obliged to use a WDS…