I changed the Exit to HD Type to Grub. This got me to the Windows 7 operating system. Updated the drivers and the firmware, just in case, PC had been sitting for awhile. Tried to deploy the Generalized Windows 10 Image and it will not install. Runs through the process 100%, reboots but goes back to Windows 7. What am I missing?

Also, FYI, I am new to FOG. Please give me details so I know what I am suppose to do.

Thanks for the help.

Liz

I have seen several posts about FOG and the error Booting from SAN Device 0x80 hangs and will not boot. They are legacy boot and Windows Server 2012.

I have a Windows 10 image that works fine for Dell Precision 3600, trying to image Dell Precision 3620 with same Windows 10 image. If I boot the computer with no network connection will login with Windows 7 image but not to the network if connected. Gives Booting from SAN Device 0x80 hangs if connected. So I have the same image and it works on the 3600 and not on 3620.

So what do I need to change so the 3620 can boot and be updated with new Windows 10 image and not make changes to impact the 3600 imaging. Same Image.

Thanks.

I will go through the information you sent, but I cannot take photo of the screen. Thanks.

Hi Everyone,

I am very new to FOG and Linux. An update to the latest version was performed in December 2019 and the capturing process began to fail. Prior to that it was perfect. Since then it captures the image and states successful, but cannot upload. I have seen many comments on this topic.

I have performed the chmod and change the permissions. I have changed /opt/fog/.fogsettings from storagelocation=‘/images’ to storagelocation=/‘home/fog/images’ and still cannot upload the image.

I have read about making sure your password in correct, can someone give me the exact steps to verify these. Right know at a loss of what to do. Thanks for helping.

Liz