@george1421 Look at you!! you are a genius. Rookie mistake, FOG_TFTP_PXE_KERNEL: bzImage_4.1.2 was the issue. Set as you listed above, presto FOG is happy again. Thank You.
joyboy11111
@joyboy11111
Best posts made by joyboy11111
-
RE: Not able to finish client registration
Latest posts made by joyboy11111
-
RE: HP Elitebook 840 G7
I updated the config file to match the wiki, leaving my ip settings. I replaced all the instances of ipxe.efi with snponly. Restarted DHCP and now nothing will pxe boot. It just sits at >>start PXE over IPv4, and times out. I went back into look at the config file and it looks empty, like everything I entered and saved is now gone.
I am about ready to see if I can start a remote session with you to see if you can straighten this out. Again I apologize for taking so much of your time.
-
RE: HP Elitebook 840 G7
@george1421 It does give me a warning about a swap file when I go to view the config.
-
RE: HP Elitebook 840 G7
There is nothing below Filename “undionly.kpxe” just blank. I tried to the search from tom /ipxe.efi, nothing, no results. should I copy and past those lines from the wiki for the rest of the config file?
-
RE: HP Elitebook 840 G7
@george1421
What line would I make the change from ipxe to snponly. -
RE: HP Elitebook 840 G7
I am very sorry it has taken me this long to get back. Several other issues came up that I needed to address.
If I am in the correct place the dhcp config file is empty. I am very sorry I am so reliant on you for step by step instructions.
is Sebastian correct in his post below also?
-
RE: HP Elitebook 840 G7
@george1421
I renamed the ipxe, and downloaded snponly. Tested with the same issue. I feel i am doing something wrong. -
RE: HP Elitebook 840 G7
@george1421
Does this give you the info you need? I use multiple adapters, eht0 is assigned to FOG. ETH1 is how I let FOG get out to the internet. -
RE: HP Elitebook 840 G7
@george1421
Those files are in the snap shot below. I tested, made sure both MAC’s were deleted from hosts. Did a quick registration and it did the same thing. Pulled the MAC of the adapter. Still shows has host not registered.Did I do something wrong?
-
RE: HP Elitebook 840 G7
So I use wget github.com… and download both files to var/www/html/fog/service/ipxe? Will that unzip and copy and replace the files in that directory?
-
RE: HP Elitebook 840 G7
When I do ipconfig /all the physical address is 60 6d 3c 79 b0 f4